Trimble Connect User Forum

 View Only
Back to discussions
Expand all | Collapse all

Objects with square edges laying flush with each other, do not render the lines between in Trimble Connect 3D Viewer.

  • 1.  Objects with square edges laying flush with each other, do not render the lines between in Trimble Connect 3D Viewer.

    Posted 04-13-2021 12:15
    I have objects in my sketchup file that are essentially cubes laying flush with each other, but in the 3d viewer, I cannot figure out how to get the line inbetween them to render.   Am I going to have to curve all the edges to make them render?

    Any help would be appreciated, thanks.

    ------------------------------
    Christopher Knutsen
    ------------------------------


  • 2.  RE: Objects with square edges laying flush with each other, do not render the lines between in Trimble Connect 3D Viewer.

    Posted 06-29-2021 05:30
    Edited by Chris Dizon 06-29-2021 05:33
    Christopher

    If you have not resolved this, most likely you have the cubes ungrouped in sketchup.   You will want to have each cube as a component or group in SketchUp so they are represented as an individual entity.  



    Hope this helps
    ChrisD


    ------------------------------
    Chris Dizon
    ------------------------------

    Original Message


  • 3.  RE: Objects with square edges laying flush with each other, do not render the lines between in Trimble Connect 3D Viewer.

    Posted 07-08-2021 06:42
    Thanks @Chris Dizon for helping out Christopher.

    Regards​​

    ------------------------------
    Darshan Rajaram Kamat
    ------------------------------

    Original Message