There have been times , when a project has been made, fabricated and shipped and installers notice a beam is missing. It is not from the point of the fabricators but the engineer didn't include the drawing ...
Trimble connect sync issue. You change it but there is no change on the servers. You reopen it and the old position is coming back. Solution: complete reset of trimble connect (read everything first): ...
Experienced the same thing today. But it worked when I used the move command. I wonder if direct coordinate entries are not saved.
Using Trimble connect. I import an IFC and change the position. When close Trimble and open; IFC going back to original position 0,0,0,. It NOT remember the new position. Any solution for this. ------------------------------ ...
Hi Mike, Very much appreciated :-) ------------------------------ Glenn Michalczyk ------------------------------