Trimble Business Center

 View Only
Expand all | Collapse all

Elevation labels offsetting in random directions

  • 1.  Elevation labels offsetting in random directions

    Posted 12-20-2019 09:56

    Elevation labels offsetting in random directions when I'm trying to label a profile on a sheet set.  I have set the offset to 0.30 in, but some of the labels are plotted at -0.03 in.  What could be causing this and how do I correct it so the labels all show up on the same side of the profile line?

     



  • 2.  Re: Elevation labels offsetting in random directions

    Posted 12-21-2019 13:26

    If you label them on the ALignment it always labels them on the "Outside of the Curve (Above when a Hump and Below when a Sag Curve

     

    I would use Interval Labels along the bottom to label these on a Profile - then they are labelled along the base of the Profile Box. 

     

    I dont think that you can always have them above or Below - I can take a look if you share the project.

     

    Alan