Nope. Still the same problem. The curb and gutter extraction is nonfunctional on my computer (actually, this is now a second computer, the company upgraded). It's been attempted on Windows 11 and Windows 10 and v5.70, v5.80, and v5.81, all with the same failing result, full program crash.
------------------------------
Andrew Haukås
------------------------------
Original Message:
Sent: 01-26-2023 11:42
From: Mark Lagerweij
Subject: Curb and Gutter Extraction Crash in 5.70
Same problem here, using version 5.81. Any solution to this bug yet?
------------------------------
Mark Lagerweij
Original Message:
Sent: 12-09-2022 11:20
From: Andrew Haukås
Subject: Curb and Gutter Extraction Crash in 5.70
Albert,
This issue has not been resolved in 5.80. Sorry I didn't get back to you sooner (tons of work isn't a bad thing). I'm attaching three files with the error messages, but the job files with scan data are too large to send. The sequence is thus:
- Set up Curb and Gutter line extraction (this only happens with the curb routine as far as I know).
- Run extraction and everything seems fine. Curbs line up nice etc.
- Finish extraction.
- Check QA/QC and create lines.
- Immediate error
- Function closes
- Program freezes up and will not close without Task Manager.
If you have a way to upload large files I can send you a couple of archived projects this has happened on, but it happens on ALL projects. LAS imports, SX10 data, SFM, doesn't seem to matter the source.