FAQ: WorksManager vs TCC features

Document created by David Kosakowski on May 24, 2020Last modified by Grant Higgins on May 25, 2020
Version 3Show Document
  • View in full screen mode


What are the features available in WorksManager that are not in TCC? I



a. A geofence based workflow, viewing device on a map, auto add a device to a project when a device enters project boundary.
b. A  device status whether my devices are running the latest designs and firmware versions. Devices are highlighted when there is a conflict.
c. Configuration settings at the project level e.g. cal, avoidance zone minimizes manual errors at the individual device/ design level.


For now, WorksManager utilizes TCC in the background. Newer technologies will replace TCC in time.