I have 2 alignments at an intersection. I cannot get one for them to elevate the target line. Both alignments have horz and vert associated
What Trimble Software are you using?
Did you have any success with the vertical design? I got this again in another project, it worked on two other islands but will not work on this one.
3D Ground Control Inc
………….Can’t have Machine Control without Ground Control………….
Website: 3D Ground Control
By opening this file you and your company are subject to the following conditions. The release of these drawing files is for informational purposes only. Electronic files can be corrupted or altered during electronic transmission (email) or disc transfer. Ground Control Inc., LLC assumes no liability for the use of this electronic file. Furthermore, Ground Control Inc., LLC assumes no liabilities for any misuse or misinterpretations made by others in reviewing these machine control files. All construction should be based off the approved and permitted set of drawings. The attached file remains the property of Ground Control Inc., LLC and is protected by copyright laws. If these conditions are unacceptable, please return this file unopened
Sent from Mail for Windows 10
Okay so it appears that you are using the Intersection tool from TBC Infrastructure Module (sorry I wasn't aware what software you were using). I have not had a lot of experience with this Module and without seeing the data it's difficult to determine what the problem is.
I would recommend contacting your dealer (or it you are a dealer, contact Construction Support) with the data to see if they can assist.
Was using the vertical design tool. Not intersectuon
Sent from my iPhone
Retrieving data ...