AnsweredAssumed Answered

Does your Earthwork Report Calculate incorrect Cut/Fill Area?

Question asked by Eric Salgado on Apr 16, 2020
Latest reply on Apr 21, 2020 by Alan Sharp

There was a change I had to make to one of my surfaces so i made a copy to keep as the original and made the changes that i needed to make. I ran earthwork report comparing the two surfaces to see how much fill id need and noticed that my cut and fill areas were high. If i manually create linework in the area that needs fill im getting around 80yd2 however the report is showing 4,000 yd² for the cut and fill "Area". there is very little cut so i dont really understand what is going on here. Ive attached an image of the isopach showing where the fill area is at and the earthwork results

Attachments

Outcomes