AnsweredAssumed Answered

Copy & Paste Error in a slope table

Question asked by Robert Stallings on Apr 28, 2020
Latest reply on May 5, 2020 by Francisco Guerrero

I'm using version 5.10.  Recently (within the past week), when using the Side Slope to add an instruction in Corridor modeling, when I build the Cut Table, the copy and paste it to the Fill Table, it loses the leading number in the stationing, and converts the cut ratio to a percent that is not accurate.  If I delete the fill table, recopy the cut table and repaste everything works.

 

As a demonstration, my station in the cut table is 1439+00.00 with a slope of -2:1.  When I copy it, it comes in as 439+00.00 with a slope of -2.03%.

Outcomes