AnsweredAssumed Answered

TBC 3.80 Cross Section Template issues

Question asked by Cliff Culhane on Jun 8, 2017

TBC 3.80. Cross section templates and surface generation. I am having consistent issues with templates not interpolating correctly to the next template and creating holes in the surfaces when adding additional templates. With that said, the crossection are only accurate at the station the template was created, not between. The software creates a series of steps between each template rather than interpolating smoothly between each station. Anyone run into this? I'm not having any luck or response that's usable from my dealer. I have done just about everything I can think of to get past this to no avail. What am I missing?