I am using a TSC3 with Access, I took a distance offset shot and when I exported my DC file the point exported is in the original position, it has not moved with required distance. Is there a setting somewhere?
After further review I have found that Access is double-applying the offset
What version of Access and what kind of export did you do?
so you have a different coördinates on the controller (point manager & Review job screens) and in your export file?
I have the same coordinates but the coordinates shown are from where the shot was taken, not the correct offset position. If I change the offset in the point manager or in TBC .job file to zero then the coordinate is in the correct position
Strange, I'm not sure on what version our TSC3's are (purchased in 2017), but offsets are calculated correct, as in our older TSC2's (2012)
We're talking here about Measure Topo | Method = Distance Offset.
When I use the ascii file converter to build a survey report these are clearly reported as below.
Retrieving data ...