AnsweredAssumed Answered

Feature Request - Angle in Corridor Slope\Elevation Instruction

Question asked by Erik Petersen on Oct 25, 2018
Latest reply on Oct 26, 2018 by Erik Petersen

I would like to be able to to Angle in the instructions under corridor modeling. I'm trying to do an angle off a known location. Rather then try to figure out the slope it would be nice to be bale to to put the desired angle in. I need to do angle of the face of the wall @ 6 degrees. See below for reference. If there is a way to do this I have not been able to figure it out. I've just done my calculations manually to figre out the percentage.

 

Thanks

 

Outcomes