When I run the tie point extraction command during the process of 2 block flights data acquired by phantom4 pro, this error "Child process Classic AT Blunder Detection terminated unexpectedly" appears. What should I do? Thanks.
same problem here - did you ever resolve this issue?
This kind of failure in UASMaster usually means there is a problem with the project or camera setup. I say it's a setup issue as the tie-point extraction process never really started.
Before running the tie-point extraction process, go into the Topo Viewer in the Georeferencing module and verify that all of the photos of the project are oriented correctly, the sidelap/overlap is correct, and the estimated position of the GCPs are near their actual location.
116 Inverness Drive East, Suite 210
Englewood, CO 80112 USA
I found my problem to be bad gnss heights - applied a 45m shift to get out of negative country and all worked well
Retrieving data ...