Trimble Access General Survey v3.21.24
Whenever I start a new job and Measure Points the default topo point number is 1035. Where do I set the default beginning point number to something else?
Thanks
Trimble Access General Survey v3.21.24
Whenever I start a new job and Measure Points the default topo point number is 1035. Where do I set the default beginning point number to something else?
Thanks
Hi David,
please have a look into this TechTip here:
TechTip - Trimble Access Software: Resetting the Default Point Name
Note: This TechTip refer to TA 2017.21 and previous versions. TA 2018.xx is using config.cfg file slightly different.
Cheers Steven
David
I think it always defaults to the last point number used in the previous job. Don't Think there is a way to set the start point number
Alan