Dean Teska

3d Utility Network Loading into Trimble Access

Discussion created by Dean Teska on Feb 13, 2019

Hey guys,

I think I'm going crazy.  I was sure that I had loaded a designer's 3d pipe network into Trimble Access as a 3d dxf, and was able to see all the pipe sizes and inverts, etc for use when assisting with facility relocations.  Now I cannot get that to load up.  Did a Trimble Access update remove this functionality?  While we aren't a utility or grading contractor we would still like to see these things for troubleshooting, clash detection etc.  Will the utility module be required to see this data now?  I would like to see it in my TSC7 the same way it shows up in TBC below . . . .

 

Thanks

 

Dean

 

Outcomes