AnsweredAssumed Answered

Enhancement Request - Trim Surface Edge

Question asked by Wayne Welshans on Apr 2, 2019
Latest reply on Apr 4, 2019 by Wayne Welshans

When using the Trim Surface Edge command, I find that nearly every time I am finished with the command that I then need to run the edge breakline command in order to prevent the trimming I just did from being undone by any command that rebuilds the surface.  It would be very helpful if within the Trim Surface Edge command, there was a "done trimming" button that the user can click on when they are done trimming the surface that automatically creates an edge breakline, or at least brings up the edge breakline command.

 

enhancement request

Outcomes