AnsweredAssumed Answered

SCS900 and SW - Sta/Offset only shown when stakeout selected

Question asked by Samuel Egelhoff on Jan 30, 2020
Latest reply on Feb 25, 2020 by Steve DiBenedetto

I have recently updated a T7 and a T10 with all windows updates as well as updating the firmware for SCS900 (3.74.18301.18) and Siteworks (1.11.19302.221). Now when either program is launched on either device, project/receiver setup complete, and corridor has been selected, I do not see any station or offset (nor ref station or offset) until I have selected a feature for stakeout. I can duplicate this result on both devices with both SCS900 and Siteworks. 


Do I need to change settings on export from TBC? Settings on the tablets? Or do I need to roll back the updates?