Trimble Connect Knowledge Center

 View Only
  • 1.  GCS900

    Posted 10-10-2021 20:22
    Hello mates,
    I have installed GCS900 system on SEM921 grader. Its configured indicate mode. This system worked normally at the beginning. But, After few days, Components are showing disconnected on display. But Radio and GPS receivers connected normally with base. Middle led of left receiver blinking and Radio led is blinking.  What is going wrong on this CB460 ? what should do next?  
    I attached screen shot.

    ------------------------------
    Munkhbaatar Oyunbaatar
    ------------------------------