Thank you for your time and recommendation on this issue. I will try this approach and see if any resolution. Thank you again Mark.
------------------------------
Leo Cortesini
------------------------------
Original Message:
Sent: 01-14-2024 13:29
From: Mark Kellaway
Subject: Survey123 Inspection - Prompt to connect to satellite
Hi Lee,
I would think that the user has the Trimble receiver set as the location provider in the Survey123 'Location' settings. If they don't need high accuracy positions they can go to 'Setting' and then 'Location' in Survey123 and select the 'Integrated Provider'.
Regards,
------------------------------
Mark Kellaway
Original Message:
Sent: 01-12-2024 12:38
From: Leo Cortesini
Subject: Survey123 Inspection - Prompt to connect to satellite
I am new to this community: Recently I created and shared with a user an inspection survey I created using ArcGIS Survey123 Connect (no geopoint required). A problem the user is having is that the tablet is constantly trying to connect to the satellite. A warning message pops up every 5 seconds (see attachment). How can this be turned off on the tablet? It seriously disrupts the survey as the user is trying to fill it out. Any help is greatly appreciated.
------------------------------
Leo Cortesini
------------------------------