Dear all,
Only recently I updated two of my three GeoXHs, a GeoXH 2008 and a GeoXH 6000, to TerraSync 5.86 (SE).
The remaining device, another GeoXH 6000, runs TerraSync 5.41 (PE).
Browsing the TerraSync support page I found an updated SBAS.ini which I installed on all three devices.
Corrections for the GeoXHs 6000 normally come from the SAPOS network via mobile data.
The GeoXH 2008 is connected to a Zephyr 2 antenna. Prior to collecting data I usually wait for SBAS corrections and a 2ft accuracy. Postprocessing will do the rest.
I set up all three mentioned devices with a good view of the PRNs 123 and 136 (EGNOS; since I am in Germany).
All three GNSS receivers were reset; only the above-mentioned PRNs were activated; the rest of the SBAS deactivated
Outcome:- the GeoXH 6000 running TS 5.86 on GNSS firmware 4.02 was able to detect and track EGNOS
- the other GeoXH 6000 with TS 5.41 and GNSS firmware 3.06 detected PRNs 123 and 136 but didn't make any use of them
- the GeoXH 2008 (TS 5.86 and firmware 2.11) detected PRN 120, which is not even in the latest SBAS.ini, and hence couldn't make use of any corrections
Do you have any ideas what could cause this? Presently only one device is working correctly regarding SBAS; the GeoXH 2008 did so as well prior to updating TerraSync.
I am looking forward to your answers.
Regards
Henning
------------------------------
Henning
------------------------------