I am using the following:
When I look at the accuracy in Trimble Mobile manager it shows ~1ft. See attached picture. However, when using the propeller app my location appears to only be within ~3ft. In the attached picture the actual location is at the lamppost but shows the blue dot about 3 ft off the lampost.
Are there any additional settings that need to be considered or other suggestion on why the difference in accuracy?
Two things to check here
It might be a good idea to reach out to your local Trimble reseller at this point. They will have specialist local knowledge to help you determine and resolve this issue
@Tom thank you very much for the suggestions.
Attached is the processing report from propeller. Based on this the Frame has been updated to NAD83(2011) (EPOCH:2010) and the Geoid to Geoid12B (Conus) as shown in the attached image.
Does it matter if NAD83(2011) (EPOCH:2010) is used versus NAD83(2011) (EPOCH:2017.5)
I will be testing this out later this morning on site.
When I went back and tested with the new Frame and Geoid settings it was even further off.
I decided to delete and reinstall both Mobile manager and the Propeller mobile. Once this was done and settings were completed again it was working perfectly!
Thank you very much for the assistance!
Great news Trent, thanks for the follow up
I was going to suggest 'turning it off/on again' but I didn't want the abuse :-)
Glad you're all working