AnsweredAssumed Answered

Overlapping Areas of Interest Error

Question asked by Tylor Foster on Oct 5, 2020
Latest reply on Oct 7, 2020 by Alan Sharp

I am trying to segregate a site takeoff by certain areas of interest. I keep getting an error that the boundaries overlap, but I am 100% certain they are not. For example I have an boundary line that is a square, and if I draw another boundary square right next to it and use the one side's two corners to snap to TBC considers that overlapping.

 

If I have these boundaries offset by 0.01 feet it won't give me there error I presume. Why can't we snap to other boundary lines in order to make sure the entirety of the site is captured?

 

It is helpful to have the total columns on the takeoff report however it doesn't total if areas are overlapping.

Outcomes