AnsweredAssumed Answered

TSC3 - Slope Staking a 3D Polyline

Question asked by on Sep 24, 2016
Latest reply on Jan 26, 2017 by Rob Koot

I'm looking to slope stake a berm using a 3D Polyline.  I have imported a dxf and a dtm from Civil 3D and was hoping to use the two in tandem.  Staking a line and to the surface works fine but slope staking seems to be an issue.  I select the polyline to slope stake from the map and then set the slope angle but then it asks for a Hinge point definition.  I was under the assumption if the 3D line has an elevation and I am staking to existing ground I shouldn't need this.  I'm not even sure how I would calculate this.  Any ideas?