AnsweredAssumed Answered

Issue with surface tie properties tab

Question asked by Matthew Pitt on Oct 15, 2018
Latest reply on Oct 17, 2018 by Alan Sharp

I'm having issues with the surface tie function,

 

I created a surface tie then went into properties to decrease the maximum spacing as at creation it doesnt seem to want to have a maximum spacing less than 0.5m, my issue is that I seem to have clicked twice on the same spot after setting the maximum spacing, this seems to have caused Business Centre to attempt to create a surface tie with a maximum spacing of 0.000, this is obviously impossible and I have ended up with this.

 

Gutted as I was about 5 minutes away from my 30 minute save reminder.

Outcomes