AnsweredAssumed Answered

Auto Update Pipe Invert in Utility Module

Question asked by Matthew Pitt on Dec 19, 2018
Latest reply on Dec 20, 2018 by Tim McClannahan

So this has started becoming a more recurrent problem now that I am modelling sites from day 1 on site.

 

I am issued with a manhole schedule with invert and cover levels, before they are approved so they change during the job.

 

Within the utilities module when you create a pipe run it is between 2 nodes, however once the nodes are selected the pipe stays at those inverts even if the inverts of the manholes change.

 

Is there any chance that the pipe invert property could be linked to the node invert rather than being a fixed value once placed?

 

It's small fry in the grand scheme I understand but it gets to the point where it's almost faster to delete the lot and start over if more than a couple of inverts get changed.

Outcomes