AnsweredAssumed Answered

Vertical Design - Bug? - Instructions don't Move with Linework

Question asked by Patrick L'heureux on Nov 20, 2019
Latest reply on Nov 21, 2019 by Tim McClannahan

I have some  building foundation linework that I moved that was part of a vertical design. I could not for the life of me figure out how to move the associated instructions as well, as a group that is. 

 

Is it possible? If not please add. Or add the ability to rotate plan view (this would be even better). I use this trick all the time when prepping building foundations that are not North-South orientated. 

 

I had to make sure everything was 100%, I turned off the auto rebuild and moved all of the linework into place. This works but defeats the purpose of using the vertical design tool. I could have used a copy and move which would have allowed me to keep the original linework tied to the vertical design in case of changes. This is probably the route I will go next time until further updates have been made. 

 

enhancement request

Outcomes