First of all, Happy New Year to everyone !
We have one Trimble R2 GNSS receiver + TSC3 control unit, with Rx radio option enabled. I tried to use it as a radio rover, but something is not working. I set up base and rover radios on the same frequency (458.60Mhz), same data format (CMR first, then tried RTCM 3.2) and same protocol and data rates (Trimtalk v1 at 9600bps), but the R2 rover doesn't get any radio corrections.
With the same configuration, another receiver we have, an old R4 is able to receive corrections from the same base.
Any thoughts about the cause ? What I'm doing wrong ?
Thank you in advance for your time !