I am working on a large project, nine miles on an interstate highway. I have a surface created by a corridor that shows an error even after rebuild (set to by user).
How can I find out what is causing the error on the surface rebuild?
bringing this back up. As I have this issue and it is not a rebuild surface issue. I have built a Roundabout and when I connect finish to the center I get this. I stepped back 1.50' from the center to not have the finish go all the way and my finish is a bit bumpy.
Where or How do we find what the issue is in the corridor?
see if this link might help could be the same issuehttps://community.trimble.com/message/27247-re-what-is-the-small-red-exclamation-dot-next-to-fg-corridor-surface?comment…
I have delete the instruction which goes from the back of curb to the center of the roundabout and the warning message goes away and comes back as soon as I place the instruction back. I have even shorten the distance to the center of the rounabout.
Retrieving data ...