Elevation labels offsetting in random directions when I'm trying to label a profile on a sheet set. I have set the offset to 0.30 in, but some of the labels are plotted at -0.03 in. What could be causing this and how do I correct it so the labels all show up on the same side of the profile line?
If you label them on the ALignment it always labels them on the "Outside of the Curve (Above when a Hump and Below when a Sag Curve
I would use Interval Labels along the bottom to label these on a Profile - then they are labelled along the base of the Profile Box.
I dont think that you can always have them above or Below - I can take a look if you share the project.