Trimble Business Center

 View Only
Expand all | Collapse all

Corridor - Target Surface w/ Negative Cut Value

  • 1.  Corridor - Target Surface w/ Negative Cut Value

    Posted 10-16-2019 11:00

    I have an alignment that runs underneath an existing roadbed surface and have built a corridor referencing the surface.  I'm attempting to intersect the existing surface from centerline at negative 2% in both directions using the Side Slope command in the Cut Slope field.  It has only allowed positive values so I'm curious if there is a different way to go about doing this?  Any feedback is much appreciated! 



  • 2.  Re: Corridor - Target Surface w/ Negative Cut Value

    Posted 10-16-2019 21:02
      |   view attached

     

     

    Set to Yes as shown. It will work.

     

    I suppose you are using TBC 5.1.

     

    On Wed, Oct 16, 2019 at 10:00 PM bbeavers99@gmail.com <trimble@jiveon.com>



  • 3.  Re: Corridor - Target Surface w/ Negative Cut Value

    Posted 10-17-2019 20:48

    Great info Saif, thanks for the reply!