Hi all,
I hope this question is not
too general, but I am rather new to Trimble Business Center and I am stuck on this particular issue in Trimble Business Center (Version 5.7).
I am attempting to georeference a LIDAR point cloud in TBC, however each iteration of georeferencing has produced a high error (.5 meters, although the data should have a vertical error of only 5 cm). I have followed the georeferencing protocol numerous times, with numerous ground control points. I have also reached out to the campus GIS specialist who is unable to help. Does anybody know why this issue might be occuring? I have ensured that all data/the project is using the same coordinate reference system, but no matter what I am always presented with an error of at least .5 meters. Thank you in advance!------------------------------
Jack Berner
------------------------------