Trimble Business Center

For the life of me, I don't understand what the point cloud inspection is telling me. I compared 2 point clouds created from the SX12 and used a tolerance of 10 and I was shown a large area in red. I then created an inspection with a tolerance of 0.05 and received almost the same results. I scratched my head on this for a minute and then went to the report and selected points that were shot from the SX12. If my tolerance was set to 10 the majority of the point deviations show 10' and when I swap to the 0.05 inspection all of the deviations are 0.05'.

I can use the inverse command to measure between either scan and the shot point to see the difference is only a few hundredths of a foot. What am I not understanding about the inspections and the tolerances?

Thanks